How to Change a Flat Tire
A blown tire is no laughing matter. Flat or blown tires often cause accidents and can scare drivers of any experience level. If you ever blow a tire while driving, you must proceed with caution and follow the necessary steps to make sure you’re safe and that your replacement or spare tire is installed properly.
Find a Safe Spot To Pull Over
In the most ideal situation, pulling off the freeway at an exit is your best option. If you can’t make it to an exit, to avoid a car accident you should find an area that’s on a straight part of the highway. If you park near a curve in the road, cars coming around the corner won’t be able to see you.
Once you pull over, don’t forget to switch on your hazard lights. It’s always good to remember every single detail when you're on the side of the road. If you become involved in an accident, you should be able to tell your lawyer that your hazard lights were on and you were in a safe spot on the side of the road.
Step 1: Retrieve the Wrench, Jack and Spare Tire
The first step to take when you change a tire is to retrieve your necessary tools and jack up the car.
For convenience, all tools should be located within the tire. Where you place the jack to lift your car depends on your vehicle, but the ideal place is between the front door and back door. Using a jack in the wrong place could cause harm to the body of your vehicle.
Use the jack to lift the car to between six and eight inches off the ground. This will give you enough room to work with.
Step 2: Loosen the Lug Nuts and Remove the Tire
Next, use your wrench to loosen the lug nuts on your tire. The lug nuts will be somewhat difficult to remove, so position the wrench in a way that allows you to put more body weight into the rotation. Remember the old adage, "right-y tighty, lefty loose-y."
Put the blown tire into the trunk of your vehicle.
Step 3: Install the New Tire
Retrieve your spare tire and line up the holes with the lug nut posts on your car. Once you’ve coordinated the holes and lug nut posts, push the tire onto the wheel until it won’t go any further. The tire should be touching the wheelbase.
After the tire is on the car, replace the lug nuts and make them as tight as possible.
Step 4: Lower the Car Back to the Ground
Once you’ve completed the installation process, lower the car to the ground. Slowly release the jack from underneath the car so you don’t cause any damage to the body.
At this time, you’ll also want to make sure the lug nuts are fully tightened while the tire is on the ground.
To avoid blown tires, take your car to a mechanic regularly to have them evaluate your tires and replace if necessary. Properly maintaining your vehicle is the best way to avoid any type of accident. Additionally, a lawyer must know what condition your vehicle was in should you be involved in an accident.